Andersen Line Tender™ Fixed Mounting — Exploded View & Mounting Instructions

Key Information

Mounting Instruction

1. Remove the circlip (1).
2. Remove pos. 2 and 9; the base plate (10) is then ready.
3. Mark the bolt holes using the base plate (10) as a template.
4. Remove the base plate and keep drilling dust away from the Line Tender™.
5. Drill the bolt holes ø6.5mm and clean the area.
6. Apply a light coat of bedding compound so that each hole is bedded.
7. Fasten the base plate with 4 M6 countersunk head screws, large washers or a backing plate.
8. Assemble in reverse order and check the Line Tender™ works correctly.

The mounting text says M6 countersunk screws; the parts list item 11 is screw M8 x 16mm (DIN963-A4-M8X16) – as printed.

Service Instruction

1. Remove the circlip (1), drum (2), roller bearing (4) and pawl controller (9).
2. Clean all moving parts with benzine. Cleaning and re-greasing the shaft (3) requires the base plate to be removed from the deck.
3. Check pawls and springs for wear and replace if necessary.
4. Reassemble, lightly greasing all moving parts – Andersen recommends ANDERSEN Winch Grease.
5. Check that the Line Tender™ works correctly.

Exploded View & Parts List – Line Tender™, Fixed Mounting ver. 1.0

Safety

• Do not install or operate the winch before reading and fully understanding the Product Manual; every operator must be trained and aware of the hazards.
• Keep children and anyone not qualified at a safe distance from the winch and from rigging or fittings under load; tie back long hair and loose clothing.
• Remove winch handles (and turn off power on electric versions) when not in use and before any maintenance.
• Lifting operations: never with the rope in the self-tailer, never using the self-tailer as a cleat, and always with two persons keeping visual contact with the load. Tie off the rope or lead it to a cleat or bollard.