Andersen Winch 91 — Product Manual

Mounting Instruction

1. Remove screw (1), cap washer (2) and circlip (3); positions 4–13 can now be removed, leaving the winch base (14).
2. Mark the bolt holes using the base as a template, then remove it so no drilling dust gets into the winch.
3. Drill the bolt holes ø6.5mm and clean the area.
4. Apply a light coat of bedding compound so each hole is bedded.
5. Fasten the base with 6 pcs M6 countersunk head screws, using large washers or a backing plate.
6. Assemble in reverse order and check the winch works correctly.

Service Instruction

Maintenance interval 1-2 years, depending on operating conditions. Dismantle as in mounting steps 1–4.

1. Clean all moving parts with white spirits / mineral spirits.
2. Check pawls and springs (5, 13) for wear and replace if necessary.
3. Reassemble, lightly greasing all moving parts.

The exploded view includes a detail of the pawl mounting direction. Service Kit No. 14 (part no. 710014) contains the service parts for this winch.