Antal Roller Cleats RC230–RC420 — Installation Manual, Exploded Views & Dimension Drawings

Models and Drawings

Exploded views exist for the black (B) and silver (SI) versions of each size; one dimension drawing covers both.

How Roller Works

• Roller is a cleat in hard black anodized or silver aluminium with two rotating horns and a peek ball that engages the open and closed positions. Turn one of the horns to shut it down.
• Closed: minimum size, and other lines cannot get caught. Open: one movement of the hand opens it, even with the line on.
• Rounded shape and smooth design, so it does not damage mooring lines.
• The horns rotate in one direction only, so the closed cleat also works as a foot rest for the crew during hard manoeuvres.

Installation

• You need: drill, sealant, Loctite 222 or 243. Studs, washers and nuts are included.
• Mounting direction: Roller mounts one way only. Find the "in" mark on the base and fit it so the arrow points inboard.
• Use the base (07) as a template to mark the anchoring holes on the deck, then drill the holes as listed in the table below.
• Cut screws and threaded studs (06) to the required length. Use Loctite 222 or 243 on the threads and sealant around all anchoring holes under the cleat base.
• Where the model has the stainless steel plate (included), fit the plate before tightening the nuts. Tighten all anchoring screws and nuts.

Weights here are from the installation manual; the dimension drawings print different weights (see the table above). Both are copied as printed.

Exploded Views

Exploded view of RC350B shown. The other models are in the PDF downloads.

Spare Part Codes

Part codes, descriptions and materials as printed on the Antal parts lists; quantities are on the drawings.

Using These Drawings

• Each exploded view names every component with its Antal code and material. Quote the model code and the part code when you ask us for a spare.
• Where a drawing has a separate parts list for a sub-assembly (sheave assembly, caps kit, screw kit), those parts are included in the table above under the same model.
• Dimension drawings give the overall dimensions, fixing-hole positions, weight and SWL (safe working load). Each sheet states its own scale: to check fit, print at full size with page scaling off and measure against a dimension printed on the sheet.
• Weight and SWL are copied as printed on each sheet; – means the value was not read from the sheet, so check the PDF.