INSTALLATION MANUAL

Heights, bury and set-up of the Forespar Marelon table pedestals: gas spring telescoping, non-gas telescoping and fixed height units, plus advice for large tables and care.

DocumentForespar Table Pedestal System Installation
FormatPDF · 1 page · 0.2 MB
LanguageEnglish
Forespar Table Pedestal System — Installation

Pedestal Types & Heights

Type Part no. Dimensions (base to base)
Gas spring telescoping #161001 & #161004 Standard bury 5" → 26" maximum height, 13" compressed height
Non-gas telescoping #161003 & #161006 Same standard dimensions; generally 30" maximum extended height with zero bury, 18" compressed
Fixed height Bases #164021 (silver coated) or #164009 ("teak-look") Up to 29" maximum (longest double tapered tube); most table heights are 25" to 27"
  • All bases are 9-3/4" diameter with a five point fastener pattern. Bases and stop collars are molded in Marelon: no metal-to-metal contact, so no corrosion.
  • Bury = portion of the pedestal tube below the deck. On gas spring units the spring travel is fixed: removing 1" of bury adds 1" to both the overall and compressed heights; adding bury lowers them.
  • Non-gas units allow more variation in bury and height, as no gas spring restricts the telescoping section.
  • Fixed height tubes: aluminum fluted tubing, clear anodized (silver look) or copper tone anodized (teak-look) to match the bases; 3" (76mm) O.D. size only.

Large Tables, Use & Care

  • Large or very heavy tables may need two pedestals: usually one gas spring and one non-gas unit, so they don't fight each other. Two gas spring units would be virtually impossible to lower.
  • Do not use any lubricants on telescoping pedestals; clean with fresh, soapy water only.
  • When lowering a gas spring unit, press down directly over the pedestal so the offset leverage of the table does not cock the tube.

Diagram D107 (second PDF) shows the standard dimensions on a gas spring unit.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual