INSTALLATION SHEET

Sail-area limits, kit contents, fasteners, endstop clearances and the mounting sequence for the 1849 Track Risers.

DocumentHarken 1849 Track Risers Installation Sheet
FormatPDF · 4 pages · 0.3 MB
LanguageEnglish
1849 Track Risers

Specifications

Raise mid-boom travelers to clear companionway hatches. The risers articulate for straight or curved track and deck crown, and take R27HB Midrange or R32HB Big Boat track.

Part no. Description Qty in kit
HCP646 Base 2 Ask us to source it →
HCP645 Riser leg 2 Ask us to source it →
MS-103 Stainless post 2 Ask us to source it →
HFS285 Snap ring 4 Ask us to source it →

Also included: 12 hexhead bolts, washers and locknuts for the track: 1/4" (6 mm) × 1" (25 mm) for Midrange track, 5/16" (8 mm) × 1 1/4" (32 mm) for Big Boat track. You supply eight 3/8" (10 mm) flathead screws with washers and nuts or locknuts, blue Loctite if using standard nuts, and two aluminium or stainless backing plates.

Do not use risers with mainsails over 50 m² (550 ft²) mid-boom or over 59 m² (650 ft²) end-boom. Spanning charts for R27HB and R32HB are on page 2 of the PDF.

Track to Risers

  • Slip three hexhead bolts into the track slider washers and track groove; line them up with the riser holes.
  • Leave room outboard of the track for the trim cap or endstop (distance A).
  • Secure with washers and locknuts; repeat on the other side.
  • Pin the bases to the riser legs with the stainless posts, no snap rings yet. Tape the base ends so a pin cannot roll overboard.

Mounting

  • Mark the outer two holes of each base on the cabintop, remove the posts, then mark the inner two.
  • Drill, clean out the dust and dry-fit; bevel the top of each hole so sealant masses there.
  • Sealant, screws through the bases, backing plates, washers and nuts; thread-locker or locknuts.
  • Refit the posts and press the snap rings in place.
Part no. Track end fitting Leave (A)
1622 Midrange trim cap 19 mm (3/4") View part →
1523 Midrange endstop 6 mm (1/4") View part →
3158 Big Boat trim cap 25 mm (1") View part →
562 Big Boat endstop 17 mm (11/16") View part →

Converting from end-boom to mid-boom sheeting raises the load on the boom: check with your sparmaker. Many mid-boom setups use two or three boom attachment points.

Parts in this Manual We Carry

Harken part numbers as printed in the installation sheet, matched to the genuine parts in our store.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual