INSTRUCTIONS

Dimensions, working load, matching drums and the bearing service procedure for the 207HP High-Performance Small Boat Upper Swivel.

DocumentHarken 207HP High-Performance Small Boat Upper Swivel Instructions
FormatPDF · 2 pages · 0.1 MB
LanguageEnglish
207HP High-Performance Small Boat Upper Swivel

Specifications

Pin-to-pin length (A) Jaw width (B) Clevis pin Ø (C) Max luff wire Ø Weight MWL Use with drum
102 mm (4") 10 mm (3/8") 8 mm (5/16") 5 mm (3/16") 193 g (6.8 oz) 907 kg (2000 lb) 208, 493L

Needle roller thrust bearings for high-load furling, such as Melges 24 systems.

Bearing Service

Disassembly

  • Tools: Harken winch grease, small flat screwdriver, solvent, hex key.
  • Remove the retaining ring and clevis pin.
  • Remove the locking set screw in the jaw of the lower assembly with a hex key; use heat if necessary.
  • Push the crosspin out and remove the clevis.
  • Pry the end of the retaining ring towards the centre and work it out of the groove in a circular motion.

Clean and Reassemble

  • Remove washers, bushings and bearing assembly; clean with solvent.
  • When dry, smear grease into the bearing assembly components.
  • Clean the other parts and reassemble in reverse order: retaining ring, washer, spacer, washer, bearing assembly (outer race, inner race), washer.
  • A drop of red Loctite on the set screw threads.

Parts in this Manual We Carry

Harken part numbers as printed in the instructions, matched to the genuine parts in our store.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual