INSTRUCTIONS

Wire range, applications, drilling and installation for the 285 Sail Chafe Protector.

DocumentHarken 285 Sail Chafe Protector Instructions
FormatPDF · 2 pages · 0.1 MB
LanguageEnglish
285 Sail Chafe Protector

Specifications

Pre-drilled for 5 mm (3/16") wire; can be drilled out to a maximum of 11 mm (7/16").

  • Lifelines: one in front of each stanchion so the genoa foot rolls over during a tack.
  • Spreader tips: one above each spreader to protect main and genoa.
  • Upper backstay: helps the upper leech of a fully battened main pass the backstay.
  • Inner forestay: faster, easier tacks around the inner forestay.

Drilling and Installation

  • Slide any two halves together until they click.
  • Drill the central hole 1 mm (1/32") larger than the wire diameter.
  • To reopen: slide a thin flat screwdriver into each side of the dovetail and wiggle towards the narrow spoke until the halves slide apart; a fid in the centre hole helps.
  • Install by sliding the two halves over the wire until the locking edges snap together.
  • Tape the wire to hold it in place; a cable tie or split washer between tape and protector helps.

Parts in this Manual We Carry

Harken part numbers as printed in the instructions, matched to the genuine parts in our store.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual