INSTALLATION SHEET

Drill and tap sizes and the mounting sequence for the 438 Cam-Matic Adapter Plate.

DocumentHarken 438 Cam-Matic Adapter Plate Installation Sheet
FormatPDF · 2 pages · 0.2 MB
LanguageEnglish
438 Cam-Matic Adapter Plate

Installation

Mounts 150 and 365 Cam-Matic cleats to rounded surfaces such as masts and booms: dinghy halyards, spinnaker pole adjusters, outhauls.

Fastener Drill Tap
10-24 9/64" 10-24
10-32 5/32" 10-32
5 mm 4.25 mm M5 × .8 mm
  • Hold the plate with the centre hole towards you: the cam pawls open this way.
  • Using the plate as a guide, drill and tap the centre hole only; screw the plate on with Loctite on the threads.
  • Drill and tap through the spar for the cam holes and fit the cam with two screws, Loctite on the threads.
  • Do not overtighten: the cam must be secure but the pawls must snap closed smartly.

All three fasteners must secure the cam and adapter. With only the centre fastener the cam can tear off the spar suddenly.

Parts in this Manual We Carry

Harken part numbers as printed in the installation sheet, matched to the genuine parts in our store.

Harken part no. Our part
438 Cam Cleats - Adapter Plate - For Carbo-Cam 365

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual