INSTRUCTIONS

Mounting screws, bolt pattern, matching blocks and swivel-arm adjustment for Harken cam swivel bases 144, 205, 216, 360, 361, 402, 403 and 1574.

DocumentHarken Cam Swivel Bases Instructions
FormatPDF · 2 pages · 0.4 MB
LanguageEnglish
Cam Swivel Bases

Specifications

Part no. Screw Ø Screw spacing (square) Use with these blocks
144, 360 #10 (5 mm) 3/4" (19 mm) 2.25", 3.00" Light Duty Hexaratchet; 57 mm, 75 mm Carbo Air blocks incl. Ratchet and Ratchamatic
205, 216, 361 #10 (5 mm) 3/4" (19 mm) Big Bullet, 2.25" Little Hexaratchet, 57 mm Carbo Air blocks
402 #10 (5 mm) 3/4" (19 mm) 57 mm Carbo Air blocks, 397, 2634
403 #10 (5 mm) 3/4" (19 mm) 57 mm Carbo Air blocks, 397, 399, 2634
1574 1/4" (6 mm) 27 mm Midrange, Hexaratchet blocks

To reach the base's maximum working load, mount it with the listed screws, washers and locknuts in all four holes.

Swivel Arm Rotation

  • There is a small amount of movement between arm and base.
  • Tighten the four mounting screws until the swivel begins to bind, then back them off.
  • Leave enough tension to slow arm rotation slightly.

Maintenance

  • Flush frequently with fresh water.
  • No grease unless the instruction sheet calls for it.
  • Discolouration around stainless holes and screws can be removed with a fine abrasive.
  • Teak cleaners and caustic solutions can discolour parts; not covered by the warranty.

Parts in this Manual We Carry

Harken part numbers as printed in the instructions, matched to the genuine parts in our store.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual