INSTALLATION SHEET

Track cutting, cockpit layout, fasteners, trim caps, control block drilling and maintenance for the earlier Midrange track, trim caps and control blocks.

DocumentHarken Midrange Track Trim Caps Installation Sheet
FormatPDF · 2 pages · 0.1 MB
LanguageEnglish
Midrange Track Trim Caps

Track and Trim Caps

  • Covers track 1511, 1535, 1596, 1602, 1610, 1616, 1617, 1618; trim caps 1524, 1525, 1621, 1622; control blocks 1516, 1517, 1518, 1519, 1520, 1521.
  • When cutting track, keep the control block stop holes clear of the track mounting holes. Cut both ends if needed.
  • Track ends, without trim caps, sit 3/4" (19 mm) from the cockpit coaming: the pivoting cam arms clear the coaming and water can pass.
  • Slide on a control block (bumper facing the car), the car, then the second block with its bumper toward the car. Keep them loose while mounting.
  • Through-bolt with 1/4" (6.5 mm) screws: flathead for 1535, 1596, 1602, 1616, 1617; hexhead for 1511, 1610, 1618.
  • Deburr the track edges and press in the 1524, 1525, 1621 or 1622 trim caps.

Control Blocks

  • Drill 5/16" (8 mm) through the top surface of the track only, 3 3/4" (95 mm) from the track end. On 1610 track take great care to drill the top surface only.
  • To mark: block flush with the track end, drive the screw against the track top, loosen and slide away, then drill.
  • Do not use the screw hole in the control block as a drill guide.
  • Short screw for low-beam track, long screw for high-beam.

Maintenance

  • Keep cars clean by flushing often with fresh water; periodically squirt a detergent/water solution into the centre openings, roll the car back and forth and flush. This matters most when the cars have not been used.
  • No spray lubricants: the balls skid instead of rolling. With a light machine oil such as 3-in-1, a single drop in each ball race only.
  • Clean the track with detergent and water. Stainless discoloration around holes, rivets and screws can be removed with a fine abrasive.
  • No grease unless the instruction sheet calls for it (winches excepted).

Inspect shackles and control block fittings often for fatigue. Every installation needs Harken track endstops; rig the control tackle so the car is stopped by the line, not by the endstops.

Parts in this Manual We Carry

Harken part numbers as printed in the installation sheet, matched to the genuine parts in our store.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual