INSTALLATION SHEET

Track cutting, cockpit layout, drilling position and screw lengths, car care and replacement parts for the Small Boat control blocks 2740, 2741, 2742 and 2743.

DocumentHarken Small Boat Control Blocks Installation Sheet
FormatPDF · 2 pages · 0.2 MB
LanguageEnglish
Small Boat Control Blocks

Track and Trim Caps

  • Covers control blocks 2740, 2741, 2742, 2743; track 373, 374, 2720, 2721, 2725, 2751; trim caps 2722, 2723.
  • When cutting track, keep the control block stop holes clear of the track mounting holes. Cut both ends if needed.
  • Track ends, without trim caps, sit 19 mm (3/4") from the edge of the cockpit coaming.
  • Control blocks go on with the bumper facing the car and stay loose while the track is mounted.
  • Through-bolt with #10 (5 mm) flathead screws; 2721 track uses slide bolts.
  • Deburr the track edges and press in the 2722 or 2723 trim caps.

Control Blocks

  • Position the block flush with the track end, drive the screw against the track top to mark it, loosen and slide the block away.
  • Drill 6 mm (15/64") through the top surface of the track only, 61 mm (2 13/32") from the track end.
  • Do not use the screw hole in the control block as a drill guide.
  • Screws: 16 mm for 373 / 2720 / 2751; 20 mm for 2721; 30 mm for 374 / 2725.

Maintenance

  • Flush cars often with fresh water; periodically squirt a detergent/water solution into the centre openings, roll the car back and forth, then flush the bearings.
  • No spray lubricants: the balls skid instead of rolling. Use 1–2 drops of McLube OneDrop (or light machine oil) on the track ball surfaces, roll the car through it and wipe off the excess. Too much oil attracts dirt.
  • Clean the track with detergent and fresh water.
  • Keep teak cleaners and caustic solutions off: discoloration is not covered by the Harken warranty.

Inspect shackles and control block fittings often for fatigue. Every installation needs Harken track endstops; arrange the control tackle so the car does not hit them under load.

Replacement Parts (2740, 2741, 2742, 2743)

Part no. Pos. Description
HFS963 1 Cheek assembly screws (2) Ask us to source it →
350 2 Cheek block View part →
H-32051A 3 Washer Ask us to source it →
HSB243 4 Bearings (34) Ask us to source it →
H-27771A 5 Sheave Ask us to source it →
HFS134 6 Cam assembly screws (2) Ask us to source it →
423 7 Micro cam cleat Ask us to source it →
HFS890 8 Cam assembly nut (2) Ask us to source it →
HSB376 9 Control block screw (set) Ask us to source it →
HFS966 9 m6 x 1 x 16mm Ask us to source it →
HFS967 9 m6 x 1 x 20mm Ask us to source it →
HFS968 9 m6 x 1 x 30mm Ask us to source it →
H-32054A 10 Control block bumpers (2) Ask us to source it →
4965 11 Harken label Ask us to source it →

Parts in this Manual We Carry

Harken part numbers as printed in the installation sheet, matched to the genuine parts in our store.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual