INSTALLATION SHEET

Installation steps and care for the Splice Links 2711, 2724, 1619 and 3153 that align low-profile track sections.

DocumentHarken Splice Links Installation Sheet
FormatPDF · 2 pages · 0.1 MB
LanguageEnglish
Splice Links

Installation

The splice link aligns low-profile track during installation.

  1. Mount the first piece of track.
  2. Press the splice link halfway into the track end.
  3. Slide the next piece of track onto the splice link.
  4. Press the track ends together tightly so the car rolls smoothly.
  5. Mount the track.

Only butt anodized track ends together, so the car rolls smoothly. No glue is needed on the splice link.

Maintenance

  • Flush cars often with fresh water; periodically squirt a detergent/water solution into the centre openings, roll the car back and forth, then flush the bearings.
  • No spray lubricants: the balls skid instead of rolling. Use 1–2 drops of McLube OneDrop (or light machine oil) on the track ball surfaces, roll the car through it and wipe off the excess. Too much oil attracts dirt.
  • Clean the track with detergent and fresh water.
  • Keep teak cleaners and caustic solutions off: discoloration is not covered by the Harken warranty.

Inspect shackles and control block fittings often for fatigue. Every installation needs Harken track endstops; arrange the control tackle so the car does not hit them under load.

Parts in this Manual We Carry

Harken part numbers as printed in the installation sheet, matched to the genuine parts in our store.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual