INSTRUCTIONS

Parts list, screw lengths by car and configuration, shortening screws, fitting sheaves and deadends, and care for the T27KIT control block kit.

DocumentHarken T27KIT Control Block Kit Instructions
FormatPDF · 2 pages · 0.3 MB
LanguageEnglish
T27KIT Control Block Kit

Kit Contents

Fits G222B Small Boat genoa lead cars and T27 / T27.HL Midrange traveler cars.

Part no. Pos. Description
H-52104 1 Sideplate (control), printed 225 mm (4) Ask us to source it →
H-51797 2 Inner race, ESP (4) Ask us to source it →
H-51799 3 Sheave assembly, ESP (4) Ask us to source it →
HFS355 4 Screw M5X35MM socket buttonhead (8) Ask us to source it →
H-51809 5 Deadend (2) Ask us to source it →
833 6 Blue Loctite Ask us to source it →

Installation

Screw Series / part no. Configuration 5 mm screw length
HFS358 T27 MR cars Sheave 20 mm (3/4") Ask us to source it →
HFS358 T27 MR cars Sheave deadend 20 mm (3/4") Ask us to source it →
HFS358 G272B genoa lead Single sheave for 2:1 20 mm (3/4") Ask us to source it →
HFS355 G272B genoa lead Single sheave and deadend for 3:1 35 mm (1 3/8") Ask us to source it →
HFS355 G224B genoa lead Double sheave for 4:1 35 mm (1 3/8") Ask us to source it →

Traveler Cars

  • Shorten the screws to 20 mm: run a 5 mm nut onto the part you keep, cut, back the nut off to clean the threads and file off burrs.
  • Remove the set screws or deadend and put a drop of blue Loctite in the threaded holes.
  • Mount the deadend or sideplate, sheave and inner race with the screws provided, sheaves to the outside.

Genoa Lead Cars

  • The 35 mm screws supplied are long enough for two sheaves on a G22 genoa lead.
  • Remove other hardware, Loctite the holes, and mount two sheave assemblies or a deadend/sheave assembly with the full-length 35 mm screws.
  • Always use the inner race with a sheave assembly.
  • Capture the control line eye splice on the deadend before installing.

Do not stack two blocks on mainsheet traveler cars, and do not stack a deadend on top of a sheave: it weakens the control assembly and the block or deadend can break.

Maintenance

  • Inspect the control line often for deterioration and replace as needed; check the blocks for wear.
  • Flush cars often with fresh water; periodically squirt a detergent/water solution into the centre openings, roll back and forth and flush.
  • No spray lubricants: the balls skid instead of rolling. 1–2 drops of McLube OneDrop (or light machine oil) on the track ball surfaces; wipe off the excess.
  • Clean the track with detergent and water; keep teak cleaners and caustics off.

Parts in this Manual We Carry

Harken part numbers as printed in the instructions, matched to the genuine parts in our store.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual