Lofrans Thetis 1002 Remote Control — Installation & User's Manual
INSTALLATION MANUAL
Specifications, socket cut-out, plug wiring and use of the Lofrans Thetis 1002 wired hand-held windlass remote.
DocumentLofrans Thetis 1002 Remote Control Installation & User's Manual
FormatPDF · 20 pages · 3.2 MB
LanguageEnglish
Technical Data
| Thetis 1002 | |
|---|---|
| Power supply | Up to 30V DC |
| Standby consumption | 0 mA |
| Consumption in use | 15 mA (12 V DC) |
| Operating temperature | -10 / +60 °C |
| Protection rating | IP67 |
| Dimensions (mm) | 154 x 59 x 38 |
| Weight (g) | 120 |
| Compliance | EN 55032: 2015; EN 55024: 2010+A1: 2015 |
DC only, load up to 2 amps: must be used with contactors or a control box.
- Normally open contacts; cable can be extended up to 4 meters; soft-finish ergonomic case.
- In the box: Thetis 1002 hand-held, cradle with 2 screws, 3-pole connector (female plug), manual.
Socket Installation & Wiring
- Drill one 20.5 mm (~13/16") hole in the dashboard (Fig. A dimensions it 20 ±1) and secure the female plug with its back locking nut; dashboard no thicker than 10mm.
- Fit the gasket between the plug and the dashboard; mount it in a dry place so the rear stays dry.
- Wires at least 1.5 mm²; 5 A fast fuse on the battery positive; do not power it from the engine battery set.
- Fix the cradle with its two screws.
| Female connector pin | Wire |
|---|---|
| 1 | Up / red |
| 2 | Down / blue |
| 3 | Common / yellow |
Using the Remote
- Push the plug into the socket and turn its locking ring clockwise until it stops.
- Switch on the power and check the buttons drive the windlass the right way; if not, swap the Up and Down wires at the socket.
- Press UP or DOWN to run the windlass; release to stop.
Never press both buttons together, and do not open the remote or plug: that breaks the watertight seal. Warranty: 2 years.
Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.
Products in this Manual
