Maxwell Anchor Windlass Control Panel P102983 (PDF)

OWNER'S MANUAL

Installation, wiring, switch-on sequence, buzzer signals and dimensions of the Maxwell P102983 push-button anchor windlass control panel.

DocumentMaxwell Anchor Windlass Control Panel P102983 Installation & User Manual

FormatPDF · 2 pages · 0.4 MB

LanguageEnglish

Technical Data & Dimensions

Item	Value
Part number	P102983
Voltage	8 – 32 Volt
Max. current	3 A
Panel face	85 × 85 mm (3 3/8" × 3 3/8")
Body diameter	ø75 mm (2 15/16")
Depth behind the mounting surface	78 mm (3 1/16"); face stands 7 mm (1/4") proud
Mounting panel thickness	Min 3 mm (1/8") – max 25 mm (1")
Free space behind the panel	Minimum 50 mm (2")

Fit the panel in the wheelhouse. The full connection diagram is in the PDF download.

Switch on the main switch.
Press the on/off switch twice: after the first press the LED flashes green and the buzzer sounds continuously; press again within 6 seconds. The LED stays green and the buzzer confirms the panel is ready.
Operate the windlass motor with the direction switch.
After use press the on/off switch once; the panel sounds a signal. It also switches off automatically 30 minutes after the last use of a direction switch.
Switch off the main switch when leaving the ship.

If two control panels are installed, never operate the windlass from both panels at the same time.

Thermal protection of the control current: on overload the panel sounds a warning once and the LED lights red and green alternately for about 7 seconds.
Once the overload is solved the system works normally again.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.