Quick IP67 Connector 71xx Series — Instructions
INSTRUCTIONS
Plug assembly, socket fitting, connection and technical data for the Quick IP67 71xx panel connectors (3 to 12 contacts).
DocumentQuick IP67 Connector 71xx Series Instructions
FormatPDF · 4 pages · 0.2 MB
LanguageEnglish
Technical Data
| Model | 7103 | 7105 | 7106 | 7107 | 7108 | 7109 | 7110 | 7112 |
|---|---|---|---|---|---|---|---|---|
| No. of contacts | 3 | 5 | 6 | 7 | 8 | 9 | 10 | 12 |
| Current per contact | 12A | 7A | 6A | 5A | 4A | 4A | 3A | 3A |
- Voltage 48V; contact resistance < 2,5 mΩ; operating temperature –20 ÷ +70 °C.
- IP67 with the plug correctly inserted in the socket, excluding the rear of the socket where the cable is soldered (IP00): keep the back of the socket dry.
- Package: grommet nut, 3 cable outlet gaskets, cap, plug inner contact fittings (with plug ring-nut and O-ring), socket (with O-ring), socket gasket-protective cap, 4 screws, manual, drill template.
| Cable outlet gaskets supplied (Tab.1): cable diameter (mm) |
|---|
| 4,5 ÷ 6,5 |
| 6,5 ÷ 8,5 |
| 7,5 ÷ 9,5 |
Plug Assembly
- Slide the grommet nut onto the cable.
- Slide on the cable outlet gasket that suits the cable diameter (Tab.1).
- Slide on the cap.
- Solder the conductors into the plug contact bushes.
- Screw the cap onto the plug contact fitting (use the socket as a tool to tighten it).
- Seat the cable gasket inside the cap.
- Tighten the grommet nut onto the cap.
Fitting the Socket
- Within easy reach; clean, smooth, flat surface; rear access for installation and cable routing; back of the socket away from water and humidity. Do not weaken the boat's structure when drilling.
- Place the drill template and mark the hole centres.
- Cut the cable hole with a milling cutter; remove the template and any splinters.
- Fit the gasket-protective cap on the socket base and pass the cable through.
- Solder the conductors to the socket bushes (supply disconnected).
- Fix the socket with the 4 screws; check all connections before powering up.
Connecting and Disconnecting
- Connect: unscrew the protective cap ring-nut anticlockwise and remove it, insert the plug the right way round, turn the plug ring-nut clockwise until fully closed.
- Disconnect: turn the plug ring-nut anticlockwise until fully open, remove the plug, refit the protective cap turning its ring-nut clockwise.
- Never connect or disconnect with current flowing through the contacts, and always cap the socket when the plug is out.
Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.
