Quick Nausicaa LED Recessed Wall Lights — Installation Instructions

Models

• The brackets adjust for panels from 1,5 mm to 12,5 mm thick.
• The LED lamps are built in and cannot be replaced.

Installation

1. Bring the cables from the constant-voltage power supply (voltage as in the chart) to the panel. The panel must not be thicker than 12.5 mm.
2. Cut the hole with the drilling template supplied.
3. Connect positive to the red cables of each module and negative to the black cables. Test the light.
4. Set the brackets to the panel thickness with the 8 screws that let them slide.
5. Insert the lighting body into the hole from the back of the panel.
6. Fix the 4 brackets with screws (not supplied) with a suitable countersunk head.
7. When finished, the lighting body must sit flush with the panel.

Wiring & Power Supply

• Do not connect directly to the mains. Use a constant-voltage power supply whose wattage is equal to or higher than the total of the lights connected.
• Several lights are connected in parallel. Example from Quick: two lights on one Quick PSCV 10W 24V constant-voltage power supply.
• Non-Quick power supplies may have a higher or lower inrush-current protection threshold, so the load may need different sizing because of the inrush current of the LED board at switch-on.

Maintenance

• Clean with a soft damp cloth. Do not use chlorine-based sanitisers or degreasers; rinse with plenty of fresh water afterwards.
• The LED lamps are built in and cannot be replaced.