Quick WCS 820 Windlass Control Board — Installation Instructions
INSTRUCTIONS
Assembly sequence, wiring to the up/down contactors and dimensions for the Quick WCS 820 windlass control board, an UP/DOWN switch to run the windlass from the helm.
DocumentQuick WCS 820 Windlass Control Board Installation Instructions
FormatPDF · 2 pages · 0.2 MB
LanguageEnglish
Assembly
| No. | Part |
|---|---|
| 1 | Shunting switch |
| 2 | Plastic washer |
| 3 | Anti-rotation washer |
| 4 | Neoprene gasket |
| 5 | Control plate |
| 6 | 4 self-tapping screws |
| 7 | WCS 820 label |
| 8 | Black shunting switch protective cap |
Assemble in the numbered order, then fit the label:
- Peel the backing from the label without touching the adhesive; clean the control plate first. Do not apply below 18 °C.
- Lay one side of the label against the edge of the control plate first, then press the whole surface down firmly.
- Remove the transparent protective film at the end.
Wiring and Dimensions
- The switch common is fed from the battery positive through a fuse; its two outputs go to the DOWN contactor and the UP contactor coils, which return to the battery negative.
- Dimensions: plate 49,8 × 74,8 mm (1 61/64 × 2 15/16"); depth behind the panel 27 mm (1 1/16"); toggle 30,4 mm (1 13/64") proud.
Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.
Products in this Manual
