OWNER'S MANUAL

Turning on, mounting, Time and Racing modes, the three start sequences, SYNC, sound signals and battery for the Ronstan ClearStart digital race timer and sailing watches.

DocumentRonstan ClearStart Race Timer & Sailing Watches Instructions
FormatPDF · 1 page · 1.6 MB
LanguageEnglish
Ronstan ClearStart Race Timer & Sailing Watches — Instructions

Turning On the Display

The display ships "turned off" to save battery. Press and hold [CLEAR], and while holding it press and hold [MODE], [SYNC] and [START/STOP] together for 5 seconds.

Race Timer Mounting

Wear the timer on the wrist or mount it on mast, boom or deck: remove the wrist strap and fix the housing through its two holes with M4 or 5/32" fasteners that do not protrude, so the timer snaps fully into the housing. Snap it in for racing and remove it afterwards for transport/security; check the snap fit is fully home before use.

Backlight, Sound & Modes

  • Backlight: in any mode press [SET]; it stays on for 4 seconds. Frequent use shortens battery life.
  • Backlight / sound on-off: in Time mode hold [SET] for 4 seconds; while the symbols flash, press [SYNC] to scroll the on/off options. To switch back on, hold [SET] for 4 seconds until a single beep. Turning off sound signals does not affect the daily alarm, and active button presses always beep.
  • Time ↔ Racing mode: hold [MODE] then press [SYNC]. The last function or start sequence used is remembered. Pressing [MODE] alone toggles functions within the current mode.

Time Mode

  • [MODE] toggles Time > Chronograph > Alarm.
  • Time: line 1 hours:minutes, line 2 day-month and seconds. [SYNC] switches 12/24 hour; [START/STOP] switches day-month / month-day.
  • Set time: hold [CLEAR] 5 seconds; seconds flash, [SYNC] zeroes them; [MODE] steps through minutes, hours, year, month, day; [SYNC] up, [START/STOP] down; [SET] saves. Changes save automatically after 8 seconds without a press.
  • Chronograph: [START/STOP] starts, stops, restarts; [CLEAR] resets. Counts to 23 hours 59 minutes 59 seconds then restarts from zero.
  • Alarm: hold [SET] 2 seconds, set minutes and hours as above, [SET] saves; [START/STOP] switches the alarm on/off. It sounds for 30 seconds; any button stops it.

Racing Mode

Line 1 shows remaining minutes:seconds, line 2 time of day. [MODE] toggles the start sequences:

Symbol Start sequence
S Standard ISAF 5,4,1,0 minute
MR Match Race 10,6,5,4,2,0 minute
1 User Set, multiples of 1 minute
  • Only one countdown can run at a time; stop it before running another sequence.
  • Count Down Repeat / Count Down & Up: in the chosen sequence hold [SET] 3 seconds to switch. Count-up shows elapsed time to 59 minutes 59 seconds, then restarts from zero.
  • User Set: press [STOP] then [CLEAR] to reset to the default 1 minute; [SYNC] adds 1 minute at a time.
  • SYNC: if the countdown was started late, press [SYNC] to drop it immediately to the next minute and carry on counting down.

Sound Signals

When Signal
Each minute Two short beeps
Preceding 1 minute (ISAF Standard), 1 minute (User Set), 2 minutes entry time (Match Racing) One short beep for each of the last 2 seconds
At 50, 40, 30, 20 seconds to go One long beep
At 15, 14, 13, 12, 11 seconds to go One short beep
At 10, 9, 8, 7, 6 seconds to go Two short beeps
At 5, 4, 3, 2, 1 seconds to go Three short beeps
At zero (end of countdown) One short beep

Battery

  • Watch: 1x CR2032 3.0 volt lithium battery.
  • Timer: 2x CR2032 3.0 volt lithium battery.
  • Battery replacement by a qualified watchmaker.

Care & Warranty

  • Rinse with fresh water after use in salt water.
  • Use only to the rated water resistant depth; do not operate buttons while submerged.
  • Avoid chemicals, sunscreens, lubricants, solvents, paint; avoid dropping it. Do not open the watch.
  • Ronstan warrants Clear Start™ watches and timers against defects in materials or workmanship for one (1) year from purchase by the original purchaser.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual