Selden Spreader Up-lights & Down-lights Instructions (PDF)

INSTRUCTIONS

Cable exit positions by mast section and the wiring routine for Selden spreader up-lights and down-lights.

DocumentSelden Spreader Up-lights & Down-lights Instructions

FormatPDF · 2 pages · 0.6 MB

LanguageEnglish

Side Position S

Section	S	Section	S
F176	B+25	C156	B-25
F194	B+28	C175	B-35
F212	B+30	C193	B-35
F228	B+28	C211	B-45
F246	B+24	C227	B-50
F265	B+26	C245	B-55
F286	B+24	C264	B-55
F305	B+24	C285	B-55
F324	B+35	C304	B-55
R370	B+45	E321, E365	B-55

Turn the mast side up.
Drill a Ø 4,9 mm hole H=200 mm above the spreader height, side position S from the table.
Enlarge to Ø 8,0mm and grind the hole inside and out.
Repeat for each spreader, then make the same holes on the opposite side.

Fit the cable conduit into the mast (see PHB 1025); mark the conduit through the Ø 8,0 mm exits.
Pull the conduit out, cut ~ Ø 20 mm holes with a hole saw, grind, and push it back.
Push a plastic rod up to the uppermost exit, attach the cable and pull it down to the extrusion end. For up- and down-light, use a cable with 3 wires to the first spreaders.
Strap the cables, fit the rubber adapter and drill Ø 4,0 mm for its screws; connect two or three wires to the connector.
Fasten the female terminals to the mast; fit the spreader, cut the light cable to length and connect the male terminal.
Check colours match in male and female terminals. Mark the down-light wire with tape. Always use the blue wire as minus (-).

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.