Spinlock Deckvest Sprayhood Fitting Instructions (PDF)

INSTRUCTIONS

How the Spinlock sprayhood attaches to each Deckvest generation – Cento, LITE, LITE+, 5D, 6D, DURO, SOLAS and VITO – and how to repack it.

DocumentSpinlock Deckvest Sprayhood Fitting Instructions

FormatPDF · 2 pages · 1.3 MB

LanguageEnglish

Fitting by Deckvest Model

Deckvest	Attachment	Steps
Deckvest Cento	Adapter with buckle onto the sprayhood buckle	Thread the adapter through the buckle, then back over through the buckle
Deckvest Lite pre 2017	Sprayhood buckle	Thread the buckle on to the webbing, then clip the buckle on the sprayhood into the buckle on the Deckvest
Deckvest Lite + / Lite 2017 >, 5D and 6D 170N / 275N, DURO / SOLAS	Webbing direct – sprayhood buckle not required	Thread the webbing through the buckle, then back over through the buckle
Deckvest Vito	Webbing pieces and toggles on the bladder	See below

Sprayhoods are fitted in front of the bladder. On the threaded versions allow 70mm of webbing from buckle to sprayhood.

Pass the two grey webbing pieces of the sprayhood into the holes on top of the bladder.
Pass the toggle on the bladder through the centre hole in the sprayhood.
Pass the toggle of the sprayhood lanyard through the front centre hole in the sprayhood.

Place the jacket on its back and lay the sprayhood out.
Concertina the top of the sprayhood.
Turn the jacket over on its front and bend the hoop section in on itself, pushing it down into the back of the jacket.
Push the sprayhood hoop down into the pocket.

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.