We Ship Worldwide! Shipping information.
INSTRUCTIONS

Dimensions, working loads, through-deck installation, caps and hook wrench for the Wichard titanium soft padeyes (3T to 10T) used for soft fastenings and soft block attachment.

DocumentWichard Titanium Soft Padeyes Instructions
FormatPDF · 5 pages · 0.7 MB
LanguageEnglish
Download PDF
SpecificationsInstallationCare & PartsProducts
Wichard Titanium Soft Padeyes — Instructions

Titanium Soft Padeyes

Ref. Designation A mm B mm C mm D mm E mm F mm G mm W.L* kg Weight kg
6671 Padeye 3T 44 15 33 10-32 40 8.5 39 3000 0,135
6672 Padeye 5T 55 18.5 41 15-40 50 11 49 5000 0,265
6673 Padeye 7,5T 64 21 46 20-45 58 13 56 7500 0,395
6674 Padeye 10T 72 22 50 20-45 56 14 64 10000 0,485
6675 Padeye 10T 72 22 50 20-55 66 14 64 10000 0,525

Material: titanium and stainless steel. C is the hole diameter to drill in the deck; D is the range shown along the barrel in the drawing (see the PDF). *Loads are given in the direction of the arrow (straight up out of the barrel); any other direction may reduce the admissible load and the user must apply an additional safety coefficient.

  • Always use a soft loop suitable for the load indicated on the padeye.
  • Marking: working load and manufacturer logo on the flange, serial number on the underside.

Wichard: not for lifting application or PPE.

Installation

  1. Choose the location (be careful of deck thickness) and drill the support to the diameter C of your padeye.
  2. Apply a marine-grade waterproof sealant between the collar of the barrel (1) and the support, then place the padeye in the hole.
  3. Lock the lower nut (2) with an open-end wrench, using the holes to hold the barrel (1) while tightening. Always choose a deck thickness adapted to the load of the padeye, or fit a reinforcement.
  4. Once the sealant has set, unscrew the upper part (3) and insert the loop on the Tbone (4).
  5. Put the loop and Tbone back in the barrel (1) and screw it back in. Pay attention to the direction of the Tbone.

Use & Care

  • Use thread locker on the screwed parts to prevent untimely loosening, following the thread locker manufacturer's instructions.
  • Tighten the parts with a hook wrench and an open-end wrench.
  • For wintering or prolonged non-use, close the padeye with the cap (5).
  • Inspect and clean regularly, especially inside, where dirt could hinder the rotation of the Tbone.

Caps & Tool (optional)

Ref. Description
66711 Cap for padeye 6671 Ask us to source it →
66721 Cap for padeye 6672 Ask us to source it →
66731 Cap for padeye 6673 Ask us to source it →
66741 Cap for padeye 6674-6675 Ask us to source it →
6670 Hook wrench Ask us to source it →

Need a part that isn't listed? Ask us to source it and quote the part number from the PDF.

Products in this Manual